Vehicle with bicycles on a rear rack
|

How to Install a Bike Rack on a Car: Trunk Rack Step-by-Step

JupiterVehicles is reader-supported. As an Amazon Associate, we earn from qualifying purchases.

A trunk-mounted rack is the most common bike rack for cars, because it doesn’t need a hitch or crossbars. Installing one takes about 10 minutes once you’ve done it once. These are general steps. Always follow your rack’s instructions and fit guide, since strap positions vary by car.

What You Need

  • A trunk rack listed as compatible with your car
  • The rack’s fit guide or instructions for your vehicle
  • A clean cloth

Step 1: Check the Fit Guide

Rack makers publish fit information showing whether a rack works on your car and how to set the arms and feet. Allen Sports, for example, asks buyers to check its website for vehicle fit. Pay attention to warnings about spoilers, plastic trunk lids and rear glass.

Step 2: Clean the Contact Points

Wipe the trunk, bumper and edges where the pads and hooks will sit. Dirt trapped under pads can scratch paint.

Step 3: Set the Rack’s Angles

Unfold the rack. Some racks need the arms and legs set to specific angles from the fit guide. Others, like the Allen Sports Deluxe, use a single configuration design, so there’s less to adjust.

Step 4: Position the Rack on the Car

Place the upper pads on the trunk lid or rear window frame and the lower pads on the bumper, as shown in the fit guide. The carry arms should point up and back.

Step 5: Attach the Straps

  1. Top straps: Hook them onto the top edge of the trunk lid or hatch.
  2. Side straps: Hook them onto the side edges of the trunk lid. They stop side-to-side movement.
  3. Bottom straps: Hook them under the bottom edge of the trunk lid or bumper.

Make sure each hook sits on metal, not glass or plastic, unless the instructions say otherwise.

Step 6: Tighten Evenly

Tighten the top straps first, then the sides, then the bottom, and repeat until the rack is firm. Tuck in or tie off loose strap ends so they don’t flap and scratch the paint.

Step 7: Shake Test

Grab the rack and push it in every direction. It shouldn’t slide on the car. If it does, retighten the straps.

Sale
Saris Bones 3-Bike Trunk Rack Bicycle Carrier, Durable, Rust-Free, Anti-Sway Straps, Fits Most Vehicles, Made in USA, Arc-Based Design, 100% Recyclable Materials
  • Trunk mounted rack carries up to three bikes, up to 35 pounds each
  • Arc-based design fits over most spoilers, and separates bikes on different levels
  • Most popular trunk rack ever sold; With more than one million in use, the simple design sets the standard for trunk racks
  • Injection -molded arms and legs are the strongest on the market

The Saris Bones 3-Bike (about $120) fits over most spoilers, according to Saris.

Step 8: Load and Recheck

Load your bikes, then recheck the straps after a few miles, because they can settle. See how to put a bike on a bike rack for loading tips.

Safety Notes

  • REI notes that trunk racks limit trunk access and that bikes may sway. Use anti-sway straps if included.
  • Keep your license plate and lights visible.
  • Don’t open the trunk with bikes loaded.

FAQ

How tight should trunk bike rack straps be?

Tight enough that the rack doesn’t move when you push it firmly. Recheck after a few miles.

Can I install a trunk rack on a car with a spoiler?

Some racks, like arc-style designs, are made to clear many spoilers. Check the maker’s fit guide.

Should I leave the trunk rack on all the time?

It’s better to remove it when not in use to protect your paint and reduce theft risk.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *